How to use your thermometer
To avoid inaccurate measurements:
1. Please make sure that the device will be used indoors only and there are no strong gusts of wind pre-sent at the time of measurement.

2. Please make sure that there is no intense motion or movement before measuring.

3. If the device is transferred from one condition to another, which has a different ambient temperature, it is suggested to wait at least 30 minutes before measuring the temperature.

4. If the person to be measured has transferred from one location to another, which has a different ambient temperature, it is suggested to wait at least 10 minutes before taking their temperature.

5. Do not hold the device for a long time, as it is highly sensitive to heat.

6. The device has undergone clinical testing, it is safe and accurate when used by the operation manual.


How to take your forehead temperature
1. When using the thermometer for the first time, please load the batteries.

2. Press and release the Thermometer (measure/mute) button for one second to power on. Press the M (mode/memory) button to choose adult or child forehead mode. Then point the temperature probe at the center of the forehead, with a distance of 0-3 cm (0-1.18 inches).

3. Press and release the thermometer (measure/mute) button. A beep is heard, and you can now read the value on the display.

NOTE: The forehead measurement is an indicative reading. The measured forehead temperature can fluctuate up to 1 ºF (0.5 ºC) from your actual body temperature. Please be aware of the factors that influence the accuracy as described in the section “TEMPERATURE TAKING TIPS” and “WARNINGS AND PRECAUTIONS”. If the eyebrow area is covered with hair, sweat, or dirt, please clean the area beforehand to improve reading accuracy. Always check if the lens is clean. Always make sure the user and the thermometer will have been in the same room for at least 30 minutes before the measurement.


How to take your ear temperature
1. Press the Thermometer (measure/mute) button to power on.

2. Remove the red probe cover; it will automatically switch between forehead & ear mode.

3. Fit the probe snuggly into the ear canal.

4. Press and release the thermometer (measure/mute) button. When a beep is heard, you can now read the value on the display.

NOTE: Please make sure that the ear is clean with no earwax or obstructions. The right ear reading may differ from the reading taken at the left ear. Therefore, always take the temperature in the same ear for consistent temperature readings.